Project Log - October, 2003 

 Project News
 February 3, 2021

 Project Log

  Horizontal Stabilizer
  Vertical Stabilizer
  Rudder II

 Wing Kit
  Fuel Tanks

 Fuselage Kit
  Aft Section
  Foreward Section
  Top Fuselage


 Firewall Forward
  Fuel System

  Finishing Up!

 Project Notes
 Project Summary
 Other Stuff

October, 2003

October 5, 2003 - 4.5 hours
I worked on the fuel system today. I am trying to get that done so I'll know where I can run wires through the floor cover. There are a lot fittings that get added to the system when one decides to go with an AFP fuel injection system. I actually enjoyed running the tubing. Now if I can just figure out how and where to mount the flow transducer.

October 14, 2003 - 4 hours
I built a little bracket for mounting the FlowScan fuel flow transducer to the floor in front of the fuel pump and filter assembly. I also worked a little bit more on fuel tubing. I also put the exhaust back on temporarily so that I will be able to check some clearances tomorrow.

October 19, 2003 - 4 hours
Worked on the wiring a little more. I got most of the SD-8 alternator wiring done. Put in the small wire that goes to the alternator and spent some time securing wire with Adel clamps.

<<September, 2003  Top  November, 2003>>

This web site and the infomation contained within it are for entertainment purposes only. The opinions expressed on construction techniques are my opinions only and should not be confused with proper construction techniques. There is undoubtedly more than one way to build an airplane and some methods that I use may or may not work in any given circumstance. If there is any question please call the kit manufacturer. I love to help but I am not responsible for the misuse of any information contained on this web site.

 February 3, 2021