Project - Notes

Home  Project News  February 3, 2021  Project Log  FAQ  Project Notes  Project Summary  Guestbook  Other Stuff

Rudder Stiffeners The rudder stiffeners are cut from some pre-punched aluminum angle. There are holes in the angle that help guide the cuts. The manual says to cut from the center of the holes. I did this and it left some 'indentations' on the flage of the stiffener. I decided that was going to be a stress concentration and I trimmed it off. Refer to this sketch Disclaimer: This web site and the infomation contained within it are for entertainment purposes only. The opinions expressed on construction techniques are my opinions only and should not be confused with proper construction techniques. There is undoubtedly more than one way to build an airplane and some methods that I use may or may not work in any given circumstance. If there is any question please call the kit manufacturer. I love to help but I am not responsible for the misuse of any information contained on this web site.

 February 3, 2021
 Email
 Home